<![CDATA[SoliForum - 3D Printing Community — Day 3- Faerie Bottle]]>2013-05-25T13:46:35ZPunBBhttps://www.soliforum.com/topic/2539/day-3-faerie-bottle/<![CDATA[Re: Day 3- Faerie Bottle]]>In case anyone was wondering about this fantastic blue color, as it almost shimmers. I got it at http://www.amazon.com/3DPrintingUSA-Tra … B00BI1AHS0]]>https://www.soliforum.com/user/1758/2013-05-25T13:46:35Zhttps://www.soliforum.com/post/24044/#p24044<![CDATA[Re: Day 3- Faerie Bottle]]>Well my clog happened at 180, I am thinking from the way it looked it got too soft and drooped. Maybe it is the enclosure. It does seem to run hotter then I set it usually. Even though I set it to 160 it often went to 165 or 170.]]>https://www.soliforum.com/user/1758/2013-05-25T11:17:27Zhttps://www.soliforum.com/post/24025/#p24025<![CDATA[Re: Day 3- Faerie Bottle]]>Very Nice, color too! I do PLA at 190° .... works great]]>https://www.soliforum.com/user/1277/2013-05-25T08:23:13Zhttps://www.soliforum.com/post/24018/#p24018<![CDATA[Re: Day 3- Faerie Bottle]]>I was just using the stock Repiter host&slicer and used the .3 profile. Since it was PLA put my extruder temp to 160 and my bed temp to 60.]]>https://www.soliforum.com/user/1758/2013-05-25T02:51:05Zhttps://www.soliforum.com/post/23998/#p23998<![CDATA[Re: Day 3- Faerie Bottle]]>Very cool! What software and settings are you using?]]>https://www.soliforum.com/user/743/2013-05-25T02:47:32Zhttps://www.soliforum.com/post/23997/#p23997<![CDATA[Day 3- Faerie Bottle]]>Day 3 of a SD2 after clearing a nasty clog- Faerie Bottle. Transparent blue PLA. I should of added some support, some dropping at the bottom but otherwise nice looking.