<![CDATA[SoliForum - 3D Printing Community — Extruder does turn on when printing]]> 2013-05-01T01:43:36Z PunBB https://www.soliforum.com/topic/2248/extruder-does-turn-on-when-printing/ <![CDATA[Re: Extruder does turn on when printing]]> There is a 'test' button somewhere near the bottom?? of the screen IIRC that disables extrusion for testing print runs... is this clicked?

EDIT: Ok I just checked it is called 'Dry Run' located in the bottom right of the manual control tab in repetier host... if it isn't this then the stepper motor shaft may be slipping inside the filament drive gear use the manual extrude buttons to check on this.

]]> https://www.soliforum.com/user/296/ 2013-05-01T01:43:36Z https://www.soliforum.com/post/21495/#p21495 <![CDATA[Re: Extruder does turn on when printing]]> Did you click "heat extruder" in manual control?

]]> https://www.soliforum.com/user/221/ 2013-05-01T01:16:42Z https://www.soliforum.com/post/21491/#p21491 <![CDATA[Re: Extruder does turn on when printing]]> Has the extruder ever worked for your before?
Are you using Repetier-Host?

]]> https://www.soliforum.com/user/366/ 2013-05-01T01:10:13Z https://www.soliforum.com/post/21490/#p21490 <![CDATA[Re: Extruder does turn on when printing]]> Is there a G code that is not being added? Do I have a button turned off?

]]> https://www.soliforum.com/user/1787/ 2013-05-01T00:48:15Z https://www.soliforum.com/post/21487/#p21487 <![CDATA[Re: Extruder does turn on when printing]]> I ment to say the Extruder does not turn on.

]]> https://www.soliforum.com/user/1787/ 2013-05-01T00:47:25Z https://www.soliforum.com/post/21486/#p21486 <![CDATA[Extruder does turn on when printing]]> Extruder does turn on when printing. X,Y, and z are runing fine. but no ABS extruded. ?

]]> https://www.soliforum.com/user/1787/ 2013-05-01T00:44:27Z https://www.soliforum.com/post/21485/#p21485