<![CDATA[SoliForum - 3D Printing Community — Questions that probably don't need a new thread]]> 2013-04-30T07:35:16Z PunBB https://www.soliforum.com/topic/2226/questions-that-probably-dont-need-a-new-thread/ <![CDATA[Re: Questions that probably don't need a new thread]]> Thanks! guys

OK, I searched, but I came up with nothing for this one...

Where can I get another one of these or another with the same specs? It's the Y belt in the back of the printer.

]]> https://www.soliforum.com/user/19/ 2013-04-30T07:35:16Z https://www.soliforum.com/post/21370/#p21370 <![CDATA[Re: Questions that probably don't need a new thread]]> You can return the hotend to SD, or thread it in tighter while hot.
PEEK + acetone is fine.

Both of these have been covered before and could have been answered by searching.

]]> https://www.soliforum.com/user/221/ 2013-04-29T17:50:24Z https://www.soliforum.com/post/21252/#p21252 <![CDATA[Re: Questions that probably don't need a new thread]]> Chemistry leads me to believe that the PEEK will resist the acetone, but I have no hands-on knowledge with it.

]]> https://www.soliforum.com/user/1557/ 2013-04-29T17:19:35Z https://www.soliforum.com/post/21248/#p21248 <![CDATA[Questions that probably don't need a new thread]]> So I'm full of stupid questions that don't really need a new thread. So am gunna post em here...
Please feel free to post your unimportant questions here too.
(This is a copy of the minor upgrades thread but these aren't upgrades.)

1. So ABS oozes out of the barrel from the PEEK and top of the nozzle, How can I make it not do that?

2. Can I put the PEEK insulator into acetone and clean off the oozed abs, or will it melt?

]]> https://www.soliforum.com/user/19/ 2013-04-29T06:22:56Z https://www.soliforum.com/post/21196/#p21196