SoliForum - 3D Printing Community — Perimeter, Infill, and Flow Rate issues.

Re: Perimeter, Infill, and Flow Rate issues.

2013-04-24T06:28:46Z

I do like Ian said, and adjust for these kinds of things in the slicing software.

Re: Perimeter, Infill, and Flow Rate issues.

2013-04-24T05:21:34Z

Really no ones has had this problem before?

Re: Perimeter, Infill, and Flow Rate issues.

2013-04-23T17:09:28Z

200c?

Re: Perimeter, Infill, and Flow Rate issues.

2013-04-23T16:57:55Z

Maybe your temp is too low

Re: Perimeter, Infill, and Flow Rate issues.

2013-04-23T16:55:02Z

What if you set a larger extrusion width in Slic3r for different areas? Like .42 for perimeters, and .5 for solid infill.

Re: Perimeter, Infill, and Flow Rate issues.

2013-04-23T16:38:35Z

Yes that is what causes my problem. If I over extrude it works fine. If I set my extrusion to be perfect it has seperated perimiters from infill.

Re: Perimeter, Infill, and Flow Rate issues.

2013-04-23T11:50:53Z

I used this method and most of my problems went away.

http://www.soliwiki.com/Calibrate_Filament_Flow

Re: Perimeter, Infill, and Flow Rate issues.

2013-04-23T06:11:24Z

You can try different slicers and see if they help. I would tweak your extrusion multiplier till you get something in between the two.

Perimeter, Infill, and Flow Rate issues.

2013-04-23T05:01:08Z

So having perfectly adjusted my extrusion settings so i get .42mm wide extrusion I have problems with infill not meeting perimiters. If I over extrude I get really strong parts with great infill/perimeter meetup, but at .42mm I have gaps like the picture below. Please help.

Edit: this happens with both kisslicer and slic3r