<![CDATA[SoliForum - 3D Printing Community — x and y axis sliders]]>2013-04-23T11:18:52ZPunBBhttps://www.soliforum.com/topic/2161/x-and-y-axis-sliders/<![CDATA[Re: x and y axis sliders]]>This is a good fix.
]]>https://www.soliforum.com/user/282/2013-04-23T11:18:52Zhttps://www.soliforum.com/post/20726/#p20726<![CDATA[Re: x and y axis sliders]]>The play doesn't really matter too much as only the bronze bushings control accuracy for an axis, however you can tighten the white blocks together just make sure you leave a little bit of play between them and the rod.]]>https://www.soliforum.com/user/296/2013-04-23T02:26:29Zhttps://www.soliforum.com/post/20700/#p20700<![CDATA[x and y axis sliders]]>I'll try to explain this. On the x axis under the extruder there are 2 plastic or whatever blocks the rear rod rides on.The same for the right side of the y axis.They seem to wear quickly even tho I greased the rods.There is noticeable play in both now. Has anybody else noticed this?]]>https://www.soliforum.com/user/574/2013-04-23T01:55:05Zhttps://www.soliforum.com/post/20694/#p20694