<![CDATA[SoliForum - 3D Printing Community — SD2 Firmware Update Issue]]> 2013-04-16T02:18:31Z PunBB https://www.soliforum.com/topic/2082/sd2-firmware-update-issue/ <![CDATA[Re: SD2 Firmware Update Issue]]> I re-installed everything again and seemed to have fixed the problem...

]]> https://www.soliforum.com/user/419/ 2013-04-16T02:18:31Z https://www.soliforum.com/post/20082/#p20082 <![CDATA[Re: SD2 Firmware Update Issue]]> A few more specifics would certainly help... win/mac/linux? what are you trying to flash the FW with?

But usually this is caused by no comms to the arduino/sanguino, first thing to check is what port it is on... this can change after a reset; second if no extra ports are showing up reinstall the ftdi drivers and make sure the usb plugs are seated on both ends.

]]> https://www.soliforum.com/user/296/ 2013-04-15T04:04:54Z https://www.soliforum.com/post/19979/#p19979 <![CDATA[Re: SD2 Firmware Update Issue]]> Now that I have tried to uninstall the recommended Solidoodle Software, I can't connect to my SD2.

Anyone know what I did wrong to mess up this much??
I even tried to flash the firmware, but I am having similar issues in that I can no longer connect to my printer... : (

]]> https://www.soliforum.com/user/419/ 2013-04-15T02:59:33Z https://www.soliforum.com/post/19974/#p19974 <![CDATA[SD2 Firmware Update Issue]]> Hello,
I keep recieving the following error message when I try to flash my firmware onto the SD2:

avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

I noticed there are other people who have experienced this error.  But no one seems to have solved the problem.

Anyone know what is going on??

]]> https://www.soliforum.com/user/419/ 2013-04-14T22:38:06Z https://www.soliforum.com/post/19936/#p19936