is it possible to post the step file for the vertical hopper? i want to do a remix that will use a gatorade bottle for a larger openning and somewhere to attach a vibration motor. thank you.
Its on thingiverse
]]>I was hunting around for a hole on the thing but no hole.
Did have fun trying to get the black clip into the bottom as I do not have the right kind of pliers, but managed it in the end.
Now working on the wiring. Really nice that I have the instructions and pictures from Jinx. My hero!!
]]>Or you can attach it with capton tape.
]]>I then downloaded "master" version from github.
Flashed the board and now its not working as before.
Motor wining all the time because some voltage is applied to it at all times regardless of the sensor reading.
It is also responds slower.
In fact, if filament gets up too quick, motor keeps spinning at max speed for no reason.
I am guessing my firmware is newer then the one filawinder came with.
Where do i get original firmware that worked ?
]]>By checking the serial number, as mentioned in the first post of this thread.
Hehe you must be new around here (sarcasm) thinking people go back that far for information.
]]>