Won this Solidoodle 3 from an auction. Just threw in a minum bid and got it. My plan was to get the stepper motors and parts. They guy from the program said he thought it was operational but hadn’t been used since 2018 or so? Anyway took a lot of fiddling but got it to print a little test coin. The left sided belt is very loose compared to right and I can see how the adjustment works with the screws up front. The other issue is the little table I had it on was swaying side to side and I think it made the slop from the loose side even worse. But it wasn’t terrible. I may yet convert this over to a RAMPS setup. Big old extruder on this. Wondered if anyone swapped that out for a more modern extruder. Anyway was cool to see this heat up and run some PLA+ https://youtube.com/shorts/euOPgxD64TM … 2V5fzCW1xi
]]>