<![CDATA[SoliForum - 3D Printing Community — filiment tangle (any suggestions)]]>2013-04-23T12:01:21ZPunBBhttps://www.soliforum.com/topic/1978/filiment-tangle-any-suggestions/<![CDATA[Re: filiment tangle (any suggestions)]]>For filament spools prone to tangling I use this by lawsy... http://www.thingiverse.com/thing:31317]]>https://www.soliforum.com/user/87/2013-04-23T12:01:21Zhttps://www.soliforum.com/post/20734/#p20734<![CDATA[Re: filiment tangle (any suggestions)]]>I took a lower tech way of doing it.
I used wire loops.
]]>https://www.soliforum.com/user/927/2013-04-23T00:24:43Zhttps://www.soliforum.com/post/20689/#p20689<![CDATA[Re: filiment tangle (any suggestions)]]>I had this issue with my octave in the normal mounted position. I made a derivative of cmetzel's design that you are using to stop it for me.
]]>https://www.soliforum.com/user/366/2013-04-06T22:35:49Zhttps://www.soliforum.com/post/18804/#p18804<![CDATA[Re: filiment tangle (any suggestions)]]>I have had similar problems with tightly wound filament. I used a piece of wire, wound on each axle and over the top of the reel to act as a bail to hold the filament in place. Worked great....]]>https://www.soliforum.com/user/99/2013-04-06T21:52:51Zhttps://www.soliforum.com/post/18803/#p18803<![CDATA[filiment tangle (any suggestions)]]>this is the 3rd toll from Octave and and they keep tangling I am thinking of cutting 12" diameter lexan disk for each side. does anyone have a better way.
