<![CDATA[SoliForum - 3D Printing Community — Print shifted half inch!]]> 2013-04-10T21:19:08Z PunBB https://www.soliforum.com/topic/1962/print-shifted-half-inch/ <![CDATA[Re: Print shifted half inch!]]> Got it working, it was the voltage on the x,y,z motors.  I adjusted it based on the troubleshooting page on solidoodle's site and now its working fantastic.

solidoodle.[com]/how-to-2/troubleshooting

Thanks all.

]]> https://www.soliforum.com/user/1467/ 2013-04-10T21:19:08Z https://www.soliforum.com/post/19322/#p19322 <![CDATA[Re: Print shifted half inch!]]> My wire harness was hitting my end stop switch.  Once I printed the wire guide it worked fine.

B

]]> https://www.soliforum.com/user/206/ 2013-04-06T02:45:02Z https://www.soliforum.com/post/18751/#p18751 <![CDATA[Re: Print shifted half inch!]]> Check your belt tensions first. That was my solution to the problem.

]]> https://www.soliforum.com/user/46/ 2013-04-05T11:04:10Z https://www.soliforum.com/post/18669/#p18669 <![CDATA[Re: Print shifted half inch!]]> Search "shifting", there are many topics on it that will be very helpful

]]> https://www.soliforum.com/user/78/ 2013-04-04T21:39:29Z https://www.soliforum.com/post/18634/#p18634 <![CDATA[Print shifted half inch!]]> Hello,

Brand new to this world, working with a solidoodle 3.  So far been pretty successful, but I am having a problem with a print shifting about a half inch, everytime.  I have tried using slicer and Skeinforge and I am getting the same thing, as far as I can see as I jump through the layers in Repetier it does not move.

Attached is an image of what happened.

This is the thing I am trying to print.

thing:30572
RasPi_Case2_Bottom_Vesa.stl

Any ideas why this would happen?  How can I troubleshoot this?

Thanks in advance...

]]> https://www.soliforum.com/user/1467/ 2013-04-04T21:12:40Z https://www.soliforum.com/post/18626/#p18626