<![CDATA[SoliForum - 3D Printing Community — Da Vinci Mini Extruder not moving]]> 2022-08-09T20:53:38Z PunBB https://www.soliforum.com/topic/19080/da-vinci-mini-extruder-not-moving/ <![CDATA[Re: Da Vinci Mini Extruder not moving]]> jthomp82 wrote:

I have a Da Vinci Mini. I recently changed the timing belt because I was getting bad prints that were out of alignment and after recalibrating saw that that may have been the cause. So I changed the belt, now I am getting 0030 errors about the Motor, which I have reconnect and can clear. However, when I go into XYZ Makersuite I can slice and send to print an object I want to print the extruder will move to the plate, but then stop and then no longer moves and will not release filament. Any ideas? Thanks!

Did you disconnect any of the endstops on purpose or by accident? If on purpose did you reconnect all of them? Sounds like it can tell where where the X and Y homes are so it is not going to move.

]]> https://www.soliforum.com/user/7731/ 2022-08-09T20:53:38Z https://www.soliforum.com/post/155426/#p155426 <![CDATA[Da Vinci Mini Extruder not moving]]> I have a Da Vinci Mini. I recently changed the timing belt because I was getting bad prints that were out of alignment and after recalibrating saw that that may have been the cause. So I changed the belt, now I am getting 0030 errors about the Motor, which I have reconnect and can clear. However, when I go into XYZ Makersuite I can slice and send to print an object I want to print the extruder will move to the plate, but then stop and then no longer moves and will not release filament. Any ideas? Thanks!

]]> https://www.soliforum.com/user/26878/ 2022-08-09T16:57:23Z https://www.soliforum.com/post/155425/#p155425