SoliForum - 3D Printing Community — no raft - starts to jam

Re: no raft - starts to jam

2013-04-02T00:11:13Z

switched to a glass bed and tried again today...

again, without the raft, the extruder seems to start closer to the bed than normal
looking at Pronterface's interpretation, it basically says the first layer's being spewed out at .2mm height... then it's going up from there...

this time it started printing (practically clear on the bed), them moved up a little and kicked out so much plastic it backfilled onto the nozzle.... (I'm assuming from the backup caused by the first layer... )

Re: no raft - starts to jam

2013-04-01T22:43:50Z

I leave both checked and set Interface Layers (integer): to 0. The only different number I have on mine from what you've got showing is that for "Interface Flow Rate Multiplier (ratio): I have 0.6 where you have 1.0. This gives me a thinner raft which is easier to peel. I almost never use raft anymore though.

Re: no raft - starts to jam

2013-04-01T20:51:36Z

do I simply deactivate both the options there? (activate raft, and orbit?)

or am I supposed to leave one of those on?

I notice in other pictures, people's prints have a perimiter printed around their parts,
mine doesn't seem to do that, or even try...

Re: no raft - starts to jam

2013-04-01T14:45:20Z

No you shouldn't have to adjust anything after disabling the raft. I don't see any issues on that tab all of the settings are okay.

Re: no raft - starts to jam

2013-03-31T17:05:21Z

with the head as low as it'll go, i can fit a 3x5 card under it without a great deal of force...

that's what's striking me as strange, the print goes off without a hook with the raft...

when i remove the raft, do i have to tweek the Z-screw stop to make up for it?

Re: no raft - starts to jam

2013-03-31T01:13:14Z

Can you post a picture screenshot of your raft tab? The non raft issue you're describing sounds like you don't have enough gap between nozzle and bed. I'd have to see your settings to see if I see any other issues.

Re: no raft - starts to jam

2013-03-30T09:31:58Z

z-height re-adjustment; kinda odd that it has 2 diffrent heights with and w/o skirt...I never used Pronterface really so I am not 100% sure tbh. CMetzel is the local expert on that program so maybe he knows...

no raft - starts to jam

2013-03-29T20:45:14Z

ok, so, using Skeinforge/Pronterface...

i can get a happy print just fine (no notable curling, little drip, etc...) with the raft on...

if i click off the raft option, on the same print,
the head starts so low that it starts jamming.. virtually no plastic is extruded (i can see residue) to the point where after a second or two the motor starts clicking 'cause it can't feed in plastic, and as soon as I stop and lower the print bed it oozes all over the place...

i know it's something simple I'm forgetting, but please, what is the problem?