SoliForum - 3D Printing Community — Set PID

Re: Set PID

2021-05-24T00:58:14Z

rerazo55 wrote:

Dear, I am from Chile and I have bought the Filastruder for a year and I still cannot operate it, from its assembly, which is very complicated, to its configuration. I'm disappointed.
I need to be told step by step to set the PID to 185 ° or any other temperature.
The post-sale service is terrible since the person who attends it does not respond adequately.
Help me set the PID
Ricardo

1: press either the up arrow or down arrow. This will make the decimal point start to blink.
2: press the left pointing arrow button to select which digit is to be changed. EX: 000.0 00.00 0.000
3: press either the up or down arrows again while in this decimal flash mode to raise or lower the digit selected.
4: press SET, it will show a number like (A100).
5: press SET again until you see the green number read the temperature you desire. The decimal will no longer blink and the red temperature will gradually approach the green value.

Re: Set PID

2021-05-23T17:08:14Z

Sounds like this project is above your technical skill. The instructions are more than adequate to get the machine running, I have built several. There is no "Set X & Y to these values" and you're done. You have to experiment a little to figure the best settings for your own particular setup. IF you would like some personal help send me a PM. My fees are reasonable.

Set PID

2021-05-23T16:34:36Z

Dear, I am from Chile and I have bought the Filastruder for a year and I still cannot operate it, from its assembly, which is very complicated, to its configuration. I'm disappointed.
I need to be told step by step to set the PID to 185 ° or any other temperature.
The post-sale service is terrible since the person who attends it does not respond adequately.
Help me set the PID

Ricardo