<![CDATA[SoliForum - 3D Printing Community — When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into]]> 2020-12-20T20:26:39Z PunBB https://www.soliforum.com/topic/18789/when-printing-from-cura-on-da-vinci-jr-10-pro-the-nozzle-digs-into/ <![CDATA[Re: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into]]> Jonahdb2 wrote:
Tin Falcon wrote:

sound like z offset needs to change

is there a z offset you recommend? also this does not happen using XYZware

I recommend to check if your printer is level first and then go into the offset settings. As far as number well I would lift it up until its not digging into the printer anymore and then adjust until its barely touching the bed.

]]> https://www.soliforum.com/user/25423/ 2020-12-20T20:26:39Z https://www.soliforum.com/post/154290/#p154290 <![CDATA[Re: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into]]> Tin Falcon wrote:

sound like z offset needs to change

is there a z offset you recommend? also this does not happen using XYZware

]]> https://www.soliforum.com/user/25402/ 2020-12-18T23:00:54Z https://www.soliforum.com/post/154282/#p154282 <![CDATA[Re: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into]]> sound like z offset needs to change

]]> https://www.soliforum.com/user/6775/ 2020-12-17T10:11:55Z https://www.soliforum.com/post/154276/#p154276 <![CDATA[When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into]]> the bed tape (this and title says it all)

]]> https://www.soliforum.com/user/25402/ 2020-12-15T15:36:45Z https://www.soliforum.com/post/154265/#p154265