<![CDATA[SoliForum - 3D Printing Community — vertical hopper stl for version 2]]> 2020-07-11T10:35:27Z PunBB https://www.soliforum.com/topic/18685/vertical-hopper-stl-for-version-2/ <![CDATA[Re: vertical hopper stl for version 2]]> looks like i had to disassemble. now to mount the hopper after i pick up some screws. thank you

]]> https://www.soliforum.com/user/24758/ 2020-07-11T10:35:27Z https://www.soliforum.com/post/153754/#p153754 <![CDATA[Re: vertical hopper stl for version 2]]> tekstyle wrote:

Oh ok. That will work! Didn’t think to rotate it 90 degrees to the side. Do I need to disassemble the whole thing or can I just rotate the barrel from the flange at where to 2 joins?

You would need to rotate it into a tighter position which might be quite difficult depending on just how tightened it already is.  It would probably be easier to just go ahead and take the 4 bolts off, rotate, and reassemble.

]]> https://www.soliforum.com/user/10612/ 2020-07-07T14:35:07Z https://www.soliforum.com/post/153736/#p153736 <![CDATA[Re: vertical hopper stl for version 2]]> Oh ok. That will work! Didn’t think to rotate it 90 degrees to the side. Do I need to disassemble the whole thing or can I just rotate the barrel from the flange at where to 2 joins?

]]> https://www.soliforum.com/user/24758/ 2020-07-02T17:18:06Z https://www.soliforum.com/post/153688/#p153688 <![CDATA[Re: vertical hopper stl for version 2]]> I use this one: https://www.thingiverse.com/thing:1195942

You may need to rotate the barrel 90 degrees to get the hole to line up since the hopper goes off to the side on v2 with this design.

]]> https://www.soliforum.com/user/10612/ 2020-07-02T15:38:55Z https://www.soliforum.com/post/153687/#p153687 <![CDATA[vertical hopper stl for version 2]]> is there a vertical hopper stl for the version 2 of the filastruder? i only found them for the version 1.

]]> https://www.soliforum.com/user/24758/ 2020-07-02T07:59:27Z https://www.soliforum.com/post/153686/#p153686