<![CDATA[SoliForum - 3D Printing Community — Motor throwing objects off turntable]]> 2020-06-12T22:43:04Z PunBB https://www.soliforum.com/topic/18656/motor-throwing-objects-off-turntable/ <![CDATA[Re: Motor throwing objects off turntable]]> hairu526 wrote:

Vixx,

You should have received a high friction liner for the turntable to prevent objects from slowly moving as the table turns.

Uriah

I did, but it also slips around, Perhaps I should score the PLA table so it has more surface area to grip the liner

]]> https://www.soliforum.com/user/24339/ 2020-06-12T22:43:04Z https://www.soliforum.com/post/153545/#p153545 <![CDATA[Re: Motor throwing objects off turntable]]> Vixx,

You should have received a high friction liner for the turntable to prevent objects from slowly moving as the table turns.

Uriah

]]> https://www.soliforum.com/user/4789/ 2020-06-12T11:39:22Z https://www.soliforum.com/post/153538/#p153538 <![CDATA[Re: Motor throwing objects off turntable]]> It should not turn fast enough to throw anything off. It should turn just a fraction, pause for the scan and repeat till done. If the start and stop is too fast you may have to look at the code and check acceleration settings.

]]> https://www.soliforum.com/user/7731/ 2020-06-12T00:49:59Z https://www.soliforum.com/post/153531/#p153531 <![CDATA[Motor throwing objects off turntable]]> One of the numerous issues I've been having with my Atlas is that about a third to halfway through a scan the objects on the turntable get thrown off of it.  This seems to happen primarily with tall or thin objects.  Is there a setting I can adjust to help with this problem?

]]> https://www.soliforum.com/user/24339/ 2020-06-12T00:22:41Z https://www.soliforum.com/post/153529/#p153529