2020-05-05T02:58:20Z PunBB https://www.soliforum.com/topic/18569/filament-bunching-up-between-extruder-gear-and-e3d-v6/ It must’ve been a clogged extruder tip, took it off and cleaned it out, now it’s printing fine.  Also ordered more tubing so I can cut it a little longer, closer to the gears.

]]> https://www.soliforum.com/user/20349/ 2020-05-05T02:58:20Z https://www.soliforum.com/post/153213/#p153213 It must’ve been a clogged extruder tip, took it off and cleaned it out, now it’s printing fine.  Also ordered more tubing so I can cut it a little longer, closer to the gears.

]]> https://www.soliforum.com/user/20349/ 2020-05-05T02:58:12Z https://www.soliforum.com/post/153212/#p153212 Not sure where the design for the mount came from but it is missing an important detail. The inlet of the hotend should be much closer to the gear or there should be a tube from the inlet right up to the gear so there is no space for the filament to move in between the gear and inlet. The there could also be a clog.

]]> https://www.soliforum.com/user/7731/ 2020-05-04T20:43:48Z https://www.soliforum.com/post/153209/#p153209 Looks like it could be a hard clog in the nozzle that's backing up the filament. I'd disassemble and clean the hotend.

]]> https://www.soliforum.com/user/2752/ 2020-05-04T20:31:20Z https://www.soliforum.com/post/153208/#p153208 This just started happening a few days ago after it has been printing pretty much flawlessly about 12 hrs a day, everyday for the past 3 weeks.  Any ideas as to what could keep causing this to happen?  This one is about 2 hours into a 2.5 hour print:

]]> https://www.soliforum.com/user/20349/ 2020-05-04T17:52:22Z https://www.soliforum.com/post/153202/#p153202