2013-03-25T03:35:28Z PunBB https://www.soliforum.com/topic/1845/test-print/ ah ah no lol I'll have to do that ,  thanks for the tip. I must have wasted just as much.

]]> https://www.soliforum.com/user/574/ 2013-03-25T03:35:28Z https://www.soliforum.com/post/17614/#p17614 Are you sure you calibrated your extrusion settings correctly?  I went through 3/4 roll of filament before I broke down and calibrated it.  I'd double check those and heat it up a little.

]]> https://www.soliforum.com/user/253/ 2013-03-25T02:50:14Z https://www.soliforum.com/post/17611/#p17611 ok thanks, I'll try that

]]> https://www.soliforum.com/user/574/ 2013-03-25T00:10:26Z https://www.soliforum.com/post/17605/#p17605 This is where the new layers start, you probably need to turn up the retraction amount in slic3r a bit and also turning off randomize start points would make it easier to clean up.

]]> https://www.soliforum.com/user/296/ 2013-03-24T23:53:46Z https://www.soliforum.com/post/17604/#p17604 Please take a look at the two pictures.This is just a simple .3mm cube print.As you can see 3 sides print perfectly but the fourth
does not.Any ideas?

]]> https://www.soliforum.com/user/574/ 2013-03-24T23:36:00Z https://www.soliforum.com/post/17603/#p17603