<![CDATA[SoliForum - 3D Printing Community — doubt printing with minimover]]>2020-02-27T09:38:57ZPunBBhttps://www.soliforum.com/topic/18449/doubt-printing-with-minimover/<![CDATA[Re: doubt printing with minimover]]>Yes, that is what I do, it is in case the meters did not always go down to use minimover, but seen the seen I use the official software that prints me better than cure (for not having to configure so much) thanks!]]>https://www.soliforum.com/user/17329/2020-02-27T09:38:57Zhttps://www.soliforum.com/post/152672/#p152672<![CDATA[Re: doubt printing with minimover]]>ebsigma wrote:
I have an emutag, if I print with minimover a file generated with a cure, is it subtracting me meters of filament in the tag?
Yes it does then you just reset the tag before it reaches zero or the printer flags it as empty.
]]>https://www.soliforum.com/user/7731/2020-02-26T22:06:44Zhttps://www.soliforum.com/post/152668/#p152668<![CDATA[doubt printing with minimover]]>I have an emutag, if I print with minimover a file generated with a cure, is it subtracting me meters of filament in the tag?]]>https://www.soliforum.com/user/17329/2020-02-26T21:08:25Zhttps://www.soliforum.com/post/152666/#p152666