<![CDATA[SoliForum - 3D Printing Community — Prints only print rough on the right side of the printer]]> 2019-11-01T09:55:25Z PunBB https://www.soliforum.com/topic/18265/prints-only-print-rough-on-the-right-side-of-the-printer/ <![CDATA[Re: Prints only print rough on the right side of the printer]]> Is it bowden fed? When it gets to the rough side the tube could be making the filament hang up

]]> https://www.soliforum.com/user/6797/ 2019-11-01T09:55:25Z https://www.soliforum.com/post/151756/#p151756 <![CDATA[Re: Prints only print rough on the right side of the printer]]> Do you have a layer fan and does it blow from only one side?

]]> https://www.soliforum.com/user/7731/ 2019-10-31T22:15:07Z https://www.soliforum.com/post/151755/#p151755 <![CDATA[Re: Prints only print rough on the right side of the printer]]> i would suggest that 220 is too hot... try 200
also make sure the spool is turning freely, not hanging up at all

]]> https://www.soliforum.com/user/10399/ 2019-10-31T21:57:04Z https://www.soliforum.com/post/151754/#p151754 <![CDATA[Prints only print rough on the right side of the printer]]> Printer: Monoprice Select v2
Filament: Overture White PLA
Printing Temp: 220º C

I just switched to this filament (cheap from Amazon) and it prints fine until it gets to the right side of the object (see attached pics).  I am at a loss for a setting to address this.  I am going to do a temperature test print as well as an overall quality check but I have not run into this before where a specific area of each print is being affected.

http://soliforum.com/i/?4K4qRMN.jpg
http://soliforum.com/i/?vXSgEwj.jpg

]]> https://www.soliforum.com/user/22880/ 2019-10-31T04:58:57Z https://www.soliforum.com/post/151753/#p151753