<![CDATA[SoliForum - 3D Printing Community — da Vinci Jr. 1.0 rebooting]]> 2019-10-27T17:31:49Z PunBB https://www.soliforum.com/topic/18237/da-vinci-jr-10-rebooting/ <![CDATA[Re: da Vinci Jr. 1.0 rebooting]]> I found out it was the power brick cable I replaced it and problem solved!

]]> https://www.soliforum.com/user/22723/ 2019-10-27T17:31:49Z https://www.soliforum.com/post/151737/#p151737 <![CDATA[Re: da Vinci Jr. 1.0 rebooting]]> Laseracid wrote:

USB its not the wifi model (i got it 2nd hand) I'll try the try a different cable but not sure why it would be rebooting from that.


The cable could have an intermittent short on the 5 volt line which is what the logic on the mainboard runs on. So every time the line shorts it causes the processor to reboot which reboots the entire machine.

]]> https://www.soliforum.com/user/7731/ 2019-10-05T19:33:11Z https://www.soliforum.com/post/151599/#p151599 <![CDATA[Re: da Vinci Jr. 1.0 rebooting]]> USB its not the wifi model (i got it 2nd hand) I'll try the try a different cable but not sure why it would be rebooting from that.

]]> https://www.soliforum.com/user/22723/ 2019-10-05T04:41:38Z https://www.soliforum.com/post/151594/#p151594 <![CDATA[Re: da Vinci Jr. 1.0 rebooting]]> Wifi or USB. Different cable? Reset wifi connection?

]]> https://www.soliforum.com/user/7731/ 2019-10-05T01:17:03Z https://www.soliforum.com/post/151593/#p151593 <![CDATA[da Vinci Jr. 1.0 rebooting]]> I just got a Jr and its rebooting on the start of each print if I start from XYZprint it is not restarting the print but if I print from SD card it will start again.

Any ideas?

]]> https://www.soliforum.com/user/22723/ 2019-10-05T01:04:56Z https://www.soliforum.com/post/151592/#p151592