SoliForum - 3D Printing Community — Does anyone have a link to this 1.27 that am am reading about

Re: Does anyone have a link to this 1.27 that am am reading about

2019-08-23T13:41:06Z

carl_m1968 wrote:

Did you try to contact them through the link in the post just above yours?

Yes. I used the above link. Uriah replied yesterday afternoon so I am all set now...

Thanks,

Dave H.

Re: Does anyone have a link to this 1.27 that am am reading about

2019-08-22T19:55:19Z

dharris2112 wrote:

I hate to resurrect an old thread but I too need the latest code. I sent a message to the support page a few days ago and have not received a reply back.
Is there anybody out there?
Thanks,
Dave H.

Did you try to contact them through the link in the post just above yours?

Re: Does anyone have a link to this 1.27 that am am reading about

2019-08-22T18:48:17Z

I hate to resurrect an old thread but I too need the latest code. I sent a message to the support page a few days ago and have not received a reply back.

Is there anybody out there?

Thanks,

Dave H.

Re: Does anyone have a link to this 1.27 that am am reading about

2019-04-28T14:12:49Z

Hi Brink,

Send us a message via the Murobo support page below and I can send you a link to latest version of the software.
http://store.murobo.com/contact-us/

Thanks,
Uriah

Re: Does anyone have a link to this 1.27 that am am reading about

2019-04-28T05:46:24Z

There's a thread here somewhere, where if you email the guy, he'll send you a link for the download.

-Kevin

Does anyone have a link to this 1.27 that am am reading about

2019-04-28T03:31:03Z

I have the license key, but the latest version that is on github seems to be 1.22. Am I looking in the wrong place? Other posts seem to indicate that there is a 1.27 out there somewhere.