<![CDATA[SoliForum - 3D Printing Community — Auger not going inside the barrel]]> 2019-04-20T08:15:18Z PunBB https://www.soliforum.com/topic/18034/auger-not-going-inside-the-barrel/ <![CDATA[Re: Auger not going inside the barrel]]> Why does it need to ?
I purposly adjust collar position to prevent it from going all the way through.

]]> https://www.soliforum.com/user/6792/ 2019-04-20T08:15:18Z https://www.soliforum.com/post/150225/#p150225 <![CDATA[Re: Auger not going inside the barrel]]> Sounds like you should contact support smile

]]> https://www.soliforum.com/user/221/ 2019-04-17T00:33:15Z https://www.soliforum.com/post/150200/#p150200 <![CDATA[Re: Auger not going inside the barrel]]> I was able sand the inner edge of barrel, now Auger is able to go through it.

But Auger is not going through other Barrel

]]> https://www.soliforum.com/user/21239/ 2019-04-16T07:53:06Z https://www.soliforum.com/post/150186/#p150186 <![CDATA[Auger not going inside the barrel]]> Hello,

I ordered 2 Filastruder kits and received my package yesterday. When checking everything, I tried to insert the Auger in to the Barrel. In one barrel, auger is not going all the way inside, it only goes 1-2 cm. In other kit, Auger goes inside but it doesn't stick out the barrel at all. Assembly manual says,

            If more than 10 mm or less than 2 mm of the feed screw sticks out, contact support.

What should I do?
Tried interchanging augers, same result.

Hope the attached picture helps.

Thanks

]]> https://www.soliforum.com/user/21239/ 2019-04-16T05:56:16Z https://www.soliforum.com/post/150185/#p150185