<![CDATA[SoliForum - 3D Printing Community — Semplify 3d question]]>2019-04-14T16:27:05ZPunBBhttps://www.soliforum.com/topic/18032/semplify-3d-question/<![CDATA[Re: Semplify 3d question]]>Heartless Keep your grammar check to yourself!!
Dale
]]>https://www.soliforum.com/user/187/2019-04-14T16:27:05Zhttps://www.soliforum.com/post/150175/#p150175<![CDATA[Re: Semplify 3d question]]>and it is sImplify3D not semplify.]]>https://www.soliforum.com/user/10399/2019-04-14T16:08:52Zhttps://www.soliforum.com/post/150174/#p150174<![CDATA[Re: Semplify 3d question]]>Depends on the print but I typically prefer prime pillar. I usually set my pillar 10mm square far out in a corner. This works well if your non print travel speeds are at least 80mm/sec.]]>https://www.soliforum.com/user/2291/2019-04-14T14:52:54Zhttps://www.soliforum.com/post/150173/#p150173<![CDATA[Semplify 3d question]]>which is best to use prime pillar or ooze shield. I am printing PETG with a dual extruder.