<![CDATA[SoliForum - 3D Printing Community — Sang 1.3a help]]> 2019-01-01T00:04:26Z PunBB https://www.soliforum.com/topic/17826/sang-13a-help/ <![CDATA[Re: Sang 1.3a help]]> hammade90 wrote:
heartless wrote:

do you have your Arduino set up properly?
Correct board selected?
Correct processor selected?
Correct COM port selected?

everything was working the other day.

That does not mean something didn't somehow get changed - check it all to verify.

also, main power "should" be shut down, for flashing you should only need USB power to the board
and no other programs connected to the printer (close RH, or whatever you use)

]]> https://www.soliforum.com/user/10399/ 2019-01-01T00:04:26Z https://www.soliforum.com/post/148236/#p148236 <![CDATA[Re: Sang 1.3a help]]> make sure no other apps (repetier host or whatever you use to control the printer) connected to printer. Disconnect or close other apps before attempt upload.

]]> https://www.soliforum.com/user/17164/ 2018-12-31T19:04:53Z https://www.soliforum.com/post/148223/#p148223 <![CDATA[Re: Sang 1.3a help]]> heartless wrote:

do you have your Arduino set up properly?
Correct board selected?
Correct processor selected?
Correct COM port selected?

everything was working the other day.

]]> https://www.soliforum.com/user/7496/ 2018-12-31T13:41:01Z https://www.soliforum.com/post/148216/#p148216 <![CDATA[Re: Sang 1.3a help]]> do you have your Arduino set up properly?
Correct board selected?
Correct processor selected?
Correct COM port selected?

]]> https://www.soliforum.com/user/10399/ 2018-12-31T13:10:24Z https://www.soliforum.com/post/148214/#p148214 <![CDATA[Sang 1.3a help]]> Binary sketch size: 54588 bytes (of a 63488 byte maximum)
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

]]> https://www.soliforum.com/user/7496/ 2018-12-31T05:02:32Z https://www.soliforum.com/post/148207/#p148207