<![CDATA[SoliForum - 3D Printing Community — Led light to each homing switch]]>2013-03-19T02:05:55ZPunBBhttps://www.soliforum.com/topic/1766/led-light-to-each-homing-switch/<![CDATA[Re: Led light to each homing switch]]>Nice to know they were hit and also set the z stop to where the table is currently at.]]>https://www.soliforum.com/user/282/2013-03-19T02:05:55Zhttps://www.soliforum.com/post/16915/#p16915<![CDATA[Re: Led light to each homing switch]]>Look here:
There's three wires on an endstop: + 5/12v signal GND
Wire an LED between signal and GND with an appropriate sized resistor for 5 or 12 volts that your jumper is set to.
]]>https://www.soliforum.com/user/221/2013-03-19T00:17:43Zhttps://www.soliforum.com/post/16905/#p16905<![CDATA[Re: Led light to each homing switch]]>I don't, but curious as to why?]]>https://www.soliforum.com/user/78/2013-03-19T00:06:08Zhttps://www.soliforum.com/post/16904/#p16904<![CDATA[Led light to each homing switch]]>Anyone know how to wire a led light to each homing switch.]]>https://www.soliforum.com/user/282/2013-03-18T23:06:26Zhttps://www.soliforum.com/post/16899/#p16899
