Did we copy verbatim my original post? 

If so, if you read on, you will find I solved all the probs with a retrograde instead of an upgrade. 

Good luck.

2018-06-04 22:34:29

    Ski52
    Member
    Online

    From: Florida USA
    Registered: 2013-10-23
    Posts: 262

Just upgraded Repetier-Host to the latest  V2.1.2.  Now the heat bed turns off when the print is finished.  The box in Printer Settings remains unchecked as it always has been.  It is somewhat annoying, cuz the heater I use now takes ~20 min to get to 65, and 40 - 45 min to get to 95.  I have always turned off the extruder, but never the heater.
Is this a RH problem or is it  something else?  I have made no changes to the machine or soft/firmware, just the RH upgrade.

SD2 - almost everything modified

Thanx
Ski

I thought this sounded familiar:
Yes, it was your original post verbatim:
http://www.soliforum.com/topic/17380/wh … -turn-off/

Did we copy verbatim my original post? 

If so, if you read on, you will find I solved all the probs with a retrograde instead of an upgrade. 

Good luck.

2018-06-04 22:34:29

    Ski52
    Member
    Online

    From: Florida USA
    Registered: 2013-10-23
    Posts: 262

Just upgraded Repetier-Host to the latest  V2.1.2.  Now the heat bed turns off when the print is finished.  The box in Printer Settings remains unchecked as it always has been.  It is somewhat annoying, cuz the heater I use now takes ~20 min to get to 65, and 40 - 45 min to get to 95.  I have always turned off the extruder, but never the heater.
Is this a RH problem or is it  something else?  I have made no changes to the machine or soft/firmware, just the RH upgrade.

SD2 - almost everything modified

Thanx
Ski

Please post your END G-code.

If so, if you read on, you will find I solved all the probs with a retrograde instead of an upgrade. 

Good luck.

2018-06-04 22:34:29

    Ski52
    Member
    Online

    From: Florida USA
    Registered: 2013-10-23
    Posts: 262

Just upgraded Repetier-Host to the latest  V2.1.2.  Now the heat bed turns off when the print is finished.  The box in Printer Settings remains unchecked as it always has been.  It is somewhat annoying, cuz the heater I use now takes ~20 min to get to 65, and 40 - 45 min to get to 95.  I have always turned off the extruder, but never the heater.
Is this a RH problem or is it  something else?  I have made no changes to the machine or soft/firmware, just the RH upgrade.

SD2 - almost everything modified

Thanx
Ski

This should disable the script that shuts the bed heater.

SD2 - almost everything modified

Thanks