<![CDATA[SoliForum - 3D Printing Community — Help - XYZ Da Vinci 1.0 JNR]]>2018-08-28T17:19:54ZPunBBhttps://www.soliforum.com/topic/17515/help-xyz-da-vinci-10-jnr/<![CDATA[Re: Help - XYZ Da Vinci 1.0 JNR]]>I've been using my Jr 1.0 with no problems with the feed tube. There is only 1 extruder and it's on the right side of the printer if you are looking at it. The feed tube connects to the filament feed drive on the left and you need to insert the tube about 3/4 of inch into the tube fitting. It's easier if you ease the left side open to help guide the tube in. Push it in, until it seats. This is the same type of tube fitting that's on the extruder, with the little black spring release ring on top.]]>https://www.soliforum.com/user/19705/2018-08-28T17:19:54Zhttps://www.soliforum.com/post/145787/#p145787<![CDATA[Re: Help - XYZ Da Vinci 1.0 JNR]]>https://www.printedsolid.com/collection … n-coupling https://www.printedsolid.com/collection … 7610453836
]]>https://www.soliforum.com/user/6775/2018-08-08T23:18:01Zhttps://www.soliforum.com/post/145487/#p145487<![CDATA[Re: Help - XYZ Da Vinci 1.0 JNR]]>Any recommendations as to where to get them and which
thanks
]]>https://www.soliforum.com/user/19578/2018-08-08T22:49:59Zhttps://www.soliforum.com/post/145486/#p145486<![CDATA[Re: Help - XYZ Da Vinci 1.0 JNR]]>elcheapo bowden tube connectors . buy some good connectors and some good tubing]]>https://www.soliforum.com/user/6775/2018-08-08T22:04:40Zhttps://www.soliforum.com/post/145485/#p145485<![CDATA[Help - XYZ Da Vinci 1.0 JNR]]>So had this printed 2 days now and each time the plastic tube comes out of left extruder and doesnt push into the printer head. Any ideas why ?