SoliForum - 3D Printing Community — da vinci mini w print too hot?

Re: da vinci mini w print too hot?

2018-06-20T13:06:14Z

Thank you for the reply. I am actually trying out the Simplify3D software, so maybe i will have a little better luck with that. There really isnt much i can change with the davinci. It says i can change the temp +or-10 degrees. I knew when i printed it i should have rotated it, but that was how the STL was set up so i thought i would give it a try.

Re: da vinci mini w print too hot?

2018-06-20T00:04:02Z

lOOK HERE

https://www.simplify3d.com/support/prin … eshooting/

Looks like over extrusion to me also looks like support material did not release well.
Depending on the PLA 205 may be fine I typical print in the 210 -215 range.
How much control do you have typically davincis use presets with little control.
also that print may print better flat.

da vinci mini w print too hot?

2018-06-18T22:38:08Z

I am new to 3D Printing. I have printed a few things, one was a robot with joints but they were fused. The other(attached pictures) was a DeLorean. It was printed on its side, and the top side came out nice but the bottom side with the supports looks bad, i am assuming it was too hot. I do not have control over the temp and it prints at over 205C. I have read that PLA really needs to be around 180. Does anyone have any ideas on what i should do?