<![CDATA[SoliForum - 3D Printing Community — X Traversing seems to be jumpy]]> 2013-03-15T14:11:59Z PunBB https://www.soliforum.com/topic/1732/x-traversing-seems-to-be-jumpy/ <![CDATA[Re: X Traversing seems to be jumpy]]> jjcuff1 wrote:

Maybe you had a command waiting from pause or prior print that did not clear, so it executed that first

Ahh, I'll have to look when I get off of work. I just wanted to see if this has happened to anyone before, of if I'm just dumb

]]> https://www.soliforum.com/user/928/ 2013-03-15T14:11:59Z https://www.soliforum.com/post/16592/#p16592 <![CDATA[Re: X Traversing seems to be jumpy]]> Maybe you had a command waiting from pause or prior print that did not clear, so it executed that first

]]> https://www.soliforum.com/user/251/ 2013-03-15T14:05:54Z https://www.soliforum.com/post/16591/#p16591 <![CDATA[X Traversing seems to be jumpy]]> I had been printing for a while last night, and after one of the prints I went to check the level of the bed. So I manually moved the Print head from Right to Left along the back of the bed, and even though I was choosing 100mm Movement (Repetier-host) it seemed to jump across the bed in 10mm increments.

When I started a print, the X seemed to move fine...

Could my print head have been to close? or was my X motor a bit warm?

]]> https://www.soliforum.com/user/928/ 2013-03-15T13:27:00Z https://www.soliforum.com/post/16585/#p16585