SoliForum - 3D Printing Community — Any way to make jr quieter/tune steppers?

Re: Any way to make jr quieter/tune steppers?

2018-04-16T22:27:56Z

I get a lot of noise on the x and y axis but nothing on the z even at max speed. I will probably try out the TL-smoother. Thanks!

Re: Any way to make jr quieter/tune steppers?

2018-04-16T10:28:34Z

If you want to go all out you could convert to ramps and add trinamic 2130 drives .

Re: Any way to make jr quieter/tune steppers?

2018-04-15T20:26:31Z

Replace step motor that require higher voltage may help. Also the step motor smoother are very hot on facebook group now, many claim it can make step motor quieter.

I have not personally tried them yet, but get many positive feed back on facebook group. I would only use them on the axis that make most noises. Some claim get better print quality on e-axis. I recommend you do your own research on google before place order.

https://www.amazon.com/BALITENSEN-TL-Sm … s=smoother

Re: Any way to make jr quieter/tune steppers?

2018-04-15T19:35:22Z

charlesmillhollin wrote:

I am running a da vinci jr with cura and all optimal settings. I noticed that the steppers are really loud and was wondering if there is any way to tune them. I don't have the greatest knowledge of the electronics in the printer so I'm just asking around. Thanks everybody!

Not while running a stock controller board. You would need to replace the stock controller with a RAMPS 1.4 or other controller that has tunable stepper drivers.

Any way to make jr quieter/tune steppers?

2018-04-15T18:16:40Z

I am running a da vinci jr with cura and all optimal settings. I noticed that the steppers are really loud and was wondering if there is any way to tune them. I don't have the greatest knowledge of the electronics in the printer so I'm just asking around. Thanks everybody!