SoliForum - 3D Printing Community — Missing Libraries

Re: Missing Libraries

2018-04-03T00:46:07Z

I'm having similar problems too. I was trying to upgrade to the 8mp camera, take advantage of the auto-calibration, and make a few other tweaks...I'm having problems with upgrading to the latest software and firmware version.

I have a good working v1.21 image, but it would be 5mp camera and manual calibration. I can host it somewhere, and post the link.

I was getting good results with that version, but was hoping to make improvements so that I could better scan 15mm soldier figures.

-Kevin

Re: Missing Libraries

2018-04-02T23:39:35Z

I have spent hours printing an Atlas scanner, this resulted in a very professional job if I do say so myself, but I have come to a very frustrating dead end when it comes to loading Freelss on to my raspberry pi 3. I have spent about 3 days trying different approaches even trying the img file from https://s3.amazonaws.com/atlas3d/2015-05-01-atlas3d.zip does not boot only coloured square
https://github.com/hairu/freelss/ has lost a heap of dependencies and gives error messages
Do I throw out my printed Atlas in the bin and forget trying to make it work

Re: Missing Libraries

2018-03-28T18:23:17Z

I have and when I use ldd /usr/local/bin/freelss it still shows that libmicrohttpd.so.10 =>not found.

Re: Missing Libraries

2018-03-28T18:17:01Z

did you try the dev package?
sudo apt-get install libmicrohttpd-dev

Missing Libraries

2018-03-28T18:04:11Z

So I'm trying to locate two libraries so I can install them to run 1.26, but I cannot find them. I am looking for libmicrohttpd.so.10 and libcrypto.so.1.0.0. Any help would greatly be appreciated.

I've used the ldd /usr/local/bin/freelss to figure out which libraries are missing. I then used sudo apt-get install apt-file
, sudo apt-file update and apt-file to search for missing libaries. Unfortunately I get an error and the program cannot find the name of the library to install. Thank you for your time

-Joe