SoliForum - 3D Printing Community — Small spool for the Da Vinci Jr 1.0 ?

Re: Small spool for the Da Vinci Jr 1.0 ?

2018-09-27T04:09:02Z

I know this is old but in case others come looking. I’ve been using MG Chemicals 500kg spools over the XZY spools, I can confirm that those DO fit the Jr (I’m using Pro but should be the same).

Re: Small spool for the Da Vinci Jr 1.0 ?

2018-03-21T19:05:39Z

french250 wrote:

Hello,
When I buy a PLA, the spool is too big for the printer.
Do you know a brand that works with the Da Vinci Jr 1.0?
Thank you very much

Most people set up a system to feed from the outside of the printer. Only XYZ brand is designed to fit this printer. Third party filament from all vendors comes on an industry standard 1KG spool. Even 500g spools still come on a half filled 1KG spool.

Small spool for the Da Vinci Jr 1.0 ?

2018-03-21T19:03:38Z

Hello,

When I buy a PLA, the spool is too big for the printer.

Do you know a brand that works with the Da Vinci Jr 1.0?

Thank you very much