SoliForum - 3D Printing Community — Spool Error 6 minutes into print. Using paper ntags

Re: Spool Error 6 minutes into print. Using paper ntags

2018-02-13T19:06:17Z

Bozotclown1970 wrote:

You do not have to stip all covers to get to the main board of a JR. Just tilt it back all the way and remove a couple of screws on the bottom and you have have full access to the mother board.

OK. Glad you said something. I never really looked to close at getting to the mother board.

Re: Spool Error 6 minutes into print. Using paper ntags

2018-02-13T18:02:28Z

You do not have to stip all covers to get to the main board of a JR. Just tilt it back all the way and remove a couple of screws on the bottom and you have have full access to the mother board.

Re: Spool Error 6 minutes into print. Using paper ntags

2018-02-13T13:37:25Z

Glad you got it working. I have had that problem with both the paper tag and the emulator. The paper tag was fixed by making sure it was as close as possible to the reader. I have other problems with it at the moment so have not tried the emulator again. I think I have a connection problem at the main board just have not had the time nor the want to strip all the covers. There is an update coming for the emulator so I will make time then.

Re: Spool Error 6 minutes into print. Using paper ntags

2018-02-11T20:28:57Z

I got it working. My paper tags must have been programmed incorrectly. I use the new NFCTag phone app on the other post to program a few tags and its working.

Spool Error 6 minutes into print. Using paper ntags

2018-02-11T19:48:54Z

Anyone have any ideas as to why I would get a spool error around 6 minutes into a print? I have tried a couple of different paper tags and each one does the same.