0030 error can be caused by multiple issue, endstop problem is only one of them, so need more information. Try power off the printer, move the hotend to right side and power on the printer,
if it is the endstop issue, your hotend will move to left when homing before printing but make big noise then stop, followed by error code 0030.
If it is the x-axis motor or x-axis belt, you hotend will not be able to move to left when homing before printing. and will report error code 0030 after a while. if you hear motor noise but hotend not moving, check the x-axis belt and pulley. if no motor noise, check motor cable.
there are other possibilities will require photo or video to identify.
Based on your description, it sounds like it's my motor! The belt is in good shape, and I can move the hot end freely along the x axis, but it doesn't reset to the default left position.
So on that- where do I get a new motor?
]]>So I'm getting a 0030 error too. But It isn't fixed by any of the above. I think it's possible the x-axis sensor has gone bad. Does anyone know where I might get a replacement?
0030 error can be caused by multiple issue, endstop problem is only one of them, so need more information. Try power off the printer, move the hotend to right side and power on the printer,
if it is the endstop issue, your hotend will move to left when homing before printing but make big noise then stop, followed by error code 0030.
If it is the x-axis motor or x-axis belt, you hotend will not be able to move to left when homing before printing. and will report error code 0030 after a while. if you hear motor noise but hotend not moving, check the x-axis belt and pulley. if no motor noise, check motor cable.
there are other possibilities will require photo or video to identify.
]]>carl_m1968 wrote:n8 wrote:So I'm getting a 0030 error too. But It isn't fixed by any of the above. I think it's possible the x-axis sensor has gone bad. Does anyone know where I might get a replacement?
You can test it by swapping it for the one in the top door. In the door channels towards the back you find one. They are the same.
Top door? Not sure what you mean by this. The Jr. Pro doesn't have a top door.
Sorry I read 1.0 only. But still all the sensors are the same so just swap one from axis to the other and see if the issue follows the sensor.
]]>n8 wrote:So I'm getting a 0030 error too. But It isn't fixed by any of the above. I think it's possible the x-axis sensor has gone bad. Does anyone know where I might get a replacement?
You can test it by swapping it for the one in the top door. In the door channels towards the back you find one. They are the same.
Top door? Not sure what you mean by this. The Jr. Pro doesn't have a top door.
]]>n8 wrote:So I'm getting a 0030 error too. But It isn't fixed by any of the above. I think it's possible the x-axis sensor has gone bad. Does anyone know where I might get a replacement?
You can test it by swapping it for the one in the top door. In the door channels towards the back you find one. They are the same.
Top door? Not sure what you mean by this. The Jr. Pro doesn't have a top door.
]]>So I'm getting a 0030 error too. But It isn't fixed by any of the above. I think it's possible the x-axis sensor has gone bad. Does anyone know where I might get a replacement?
You can test it by swapping it for the one in the top door. In the door channels towards the back you find one. They are the same.
]]>Thanks so much, that did it!
Printed the sample and away we go!. Thanks so much for your help Yizhou.he.
You are very welcome
]]>Printed the sample and away we go!. Thanks so much for your help Yizhou.he.
]]>