<![CDATA[SoliForum - 3D Printing Community — RH losing values in FIRMWARE]]> 2013-03-13T19:29:08Z PunBB https://www.soliforum.com/topic/1688/rh-losing-values-in-firmware/ <![CDATA[Re: RH losing values in FIRMWARE]]> LOL changed this should help out the next guy

]]> https://www.soliforum.com/user/251/ 2013-03-13T19:29:08Z https://www.soliforum.com/post/16358/#p16358 <![CDATA[Re: RH losing values in FIRMWARE]]> Not that I would have been any help on this but I thought SAGA was a brand name or something so I didn't look at the thread originally.   Good that you're up and running again.

]]> https://www.soliforum.com/user/78/ 2013-03-13T19:25:19Z https://www.soliforum.com/post/16352/#p16352 <![CDATA[Re: RH losing values in FIRMWARE]]> Well I finally got it to respond again.

I loaded up into Pronterface (has same problem) but it accepted the M500 line
So I manually entered M92,M201,M203,M204,M205,M301 from marlin.pde file into Pronterface and did a M500
then M501 and they were there. Now The motors moved but apparently Y had locked up again bound so hence why my print stopped probably locked up really bad

I went back into RH and it recognized the eprom data and loaded the values. I was up and running again.

]]> https://www.soliforum.com/user/251/ 2013-03-13T18:36:59Z https://www.soliforum.com/post/16343/#p16343 <![CDATA[RH losing values in FIRMWARE]]> Well battling y axis problems thought I had it licked last night. Had my first good print in over a week, alignment feels solid.
switched to glass bed (OMG) should have done that from start

All my default values in RH load up as zero!
I relaoded everythign and it works but just heaters turn on/off

I can send M92 and M201 codes then manually drive the motors but they just barely budge..

]]> https://www.soliforum.com/user/251/ 2013-03-12T12:25:29Z https://www.soliforum.com/post/16117/#p16117