2013-03-12T14:46:36Z PunBB https://www.soliforum.com/topic/1659/pid-calibration-on-mac-rh-blank-eeprom-config-page/ Example of mcode writing/saving without the EEPROM setting screen here:
http://www.soliforum.com/post/13352/#p13352

]]> https://www.soliforum.com/user/366/ 2013-03-12T14:46:36Z https://www.soliforum.com/post/16138/#p16138 Cool- thank you.

]]> https://www.soliforum.com/user/18/ 2013-03-12T14:34:10Z https://www.soliforum.com/post/16136/#p16136 As far as I know this is a known issue with the Mac version. You still can use a g-code command to store the settings. You can test if it stored by resetting the printer, as the blurb that it spits out in the log should have the new values.

]]> https://www.soliforum.com/user/51/ 2013-03-10T21:34:01Z https://www.soliforum.com/post/15888/#p15888 So I ended up replacing my hot end after the wire finally broke at the ceramic, settled on the qu-bd part with 3w resistor. The guide was awesome, but unfortunately when I brought up EEPROM config page on RH, it was a blank page with no buttons. Do I have RH installed correctly? It has been working great for everything but the config page. Any other Mac Repetier-Host users out there with the same issue?

]]> https://www.soliforum.com/user/18/ 2013-03-10T19:57:40Z https://www.soliforum.com/post/15869/#p15869