seven2099 wrote:

Kronikabuse wrote:

www.printitindustries.com has them. or you could upgrade to a better controller cheaply with a ramps 1.4 board or for a bit more money (completely worth it) a duet wifi. youll need to do some wiring with both

Thanks for the response man.

I dont see to find it anywhere on the site.

Its worth mentioning I have a solidoodle press and while I've read about ramps, rumba and other boards I can't seem to find anyone who gets it fully working again - including the auto bed leveling (with a clear guide on what to do)

Any help you can provide would be appreciated - will gladly read up however I'm not even sure what the parts list I'd need to purchase.

https://www.printitindustries.com/produ … wer-supply

Thanks sir

However it's actually the motherboard, not the PSU. As I said in my original post, I've tested the PSU and its definitely outputting 24v.

Motherboard however fails to light up anymore.

I've also posted in the press section and no answers yet

Kronikabuse wrote:

www.printitindustries.com has them. or you could upgrade to a better controller cheaply with a ramps 1.4 board or for a bit more money (completely worth it) a duet wifi. youll need to do some wiring with both

Thanks for the response man.

I dont see to find it anywhere on the site.

Its worth mentioning I have a solidoodle press and while I've read about ramps, rumba and other boards I can't seem to find anyone who gets it fully working again - including the auto bed leveling (with a clear guide on what to do)

Any help you can provide would be appreciated - will gladly read up however I'm not even sure what the parts list I'd need to purchase.

https://www.printitindustries.com/produ … wer-supply

www.printitindustries.com has them. or you could upgrade to a better controller cheaply with a ramps 1.4 board or for a bit more money (completely worth it) a duet wifi. youll need to do some wiring with both

Thanks for the response man.

I dont see to find it anywhere on the site.

Its worth mentioning I have a solidoodle press and while I've read about ramps, rumba and other boards I can't seem to find anyone who gets it fully working again - including the auto bed leveling (with a clear guide on what to do)

Any help you can provide would be appreciated - will gladly read up however I'm not even sure what the parts list I'd need to purchase.

Seems my solidoodle motherboard has gone caput. Either that or the PSU has died, however when measuring with multimeter it seems i'm getting the 24v DC that should be coming out of there.

Is there any known plug and play replacements for this board?

Kind regards,

Seven