<![CDATA[SoliForum - 3D Printing Community — Brand new davinci 1.0 pro stepper hitting the side]]>2017-05-31T21:18:40ZPunBBhttps://www.soliforum.com/topic/16479/brand-new-davinci-10-pro-stepper-hitting-the-side/<![CDATA[Re: Brand new davinci 1.0 pro stepper hitting the side]]>Problem solved, removed the rear panel and the x and z axis stepper connectors were loose, when re-seated all was well.]]>https://www.soliforum.com/user/12841/2017-05-31T21:18:40Zhttps://www.soliforum.com/post/135778/#p135778<![CDATA[Re: Brand new davinci 1.0 pro stepper hitting the side]]>Good idea I'll get him to give it a try or check the output with a meter.]]>https://www.soliforum.com/user/12841/2017-05-30T21:28:30Zhttps://www.soliforum.com/post/135757/#p135757<![CDATA[Re: Brand new davinci 1.0 pro stepper hitting the side]]>The endstop it's self could be bad. just swap it for another and see if the problem follows the endstop. Did he buy it new or used? If used is the firmware stock?]]>https://www.soliforum.com/user/7731/2017-05-30T21:09:32Zhttps://www.soliforum.com/post/135756/#p135756<![CDATA[Brand new davinci 1.0 pro stepper hitting the side]]>I have a friend who has just bought a new 1.0 pro and whenever he tries to calibrate, the x axis, I think, just hits the side and the stepper bangs. He's check the end stop wiring and it looks good.