SoliForum - 3D Printing Community — Custom Figure - Iron Knight

Re: Custom Figure - Iron Knight

2017-05-05T00:09:10Z

...aaaaand an itty bitty kitty face :3

I finally managed to find the .1 mm setting.

Re: Custom Figure - Iron Knight

2017-05-03T22:30:45Z

Added some pauldrons:

Re: Custom Figure - Iron Knight

2017-04-30T19:31:33Z

Blender intimidated me for over four years until I finally bit the bullet. Now I use it nearly everyday. You can't go wrong with free stuff.

Torso came out well. Glued the two haves together with a gluestick and did a bit of coloring with sharpie. Might make another version with the two colors separated- easier to spraypaint.

Back side doesn't show up very well on camera

Cut the legs up into these little pieces: they're currently printing. Decided against articulated joints until I can find a good base to work off.

edit: leg bits printed and assembled... ish. Being held together with wall putty XD

Re: Custom Figure - Iron Knight

2017-04-30T17:02:08Z

Neat! look forward to seeing the prints.

knowack wrote:

What software is that screenshot?

Definitely Blender, =P

Re: Custom Figure - Iron Knight

2017-04-30T03:30:49Z

knowack wrote:

What software is that screenshot?

That's Blender.

OP- looks great

Re: Custom Figure - Iron Knight

2017-04-30T01:20:36Z

What software is that screenshot?

Re: Custom Figure - Iron Knight

2017-04-29T15:30:53Z

looks good

Custom Figure - Iron Knight

2017-04-29T15:27:28Z

So, being the goob that I am, I am transforming a 3d model I use in my webcomic (http://everett.webcomic.ws/blog)into a figure via the Davinci Jr.

I have to trace over the original as I didn't make it watertight, while I'm at it I'll have to decide what sort of joint system I'll be using (if any) Estimated height 6".

Already printed a logo sort of thing -my first print after a few presets. Accidentally used spray-on rubber instead of spraypaint XD