SoliForum - 3D Printing Community — Hello from New Zealand

Re: Hello from New Zealand

2018-01-13T12:13:57Z

Hello, I am from Indonesia.

Re: Hello from New Zealand

2017-10-12T06:00:41Z

thats interesting!

Re: Hello from New Zealand

2017-10-12T05:56:15Z

hi...

Re: Hello from New Zealand

2017-04-20T20:46:11Z

Be sure to read up on Marlin Firmware or Repetier-Firmware. Correctly configuring the firmware is a key step to a fully functional printer.

Re: Hello from New Zealand

2017-04-20T06:55:14Z

Hmm, good question. I did download and install a firmware update. It's open source so I'll have a look though and see what I can see. Thanks for the tip.

Re: Hello from New Zealand

2017-04-18T13:47:31Z

Welcome, do you have the bed heater enabled in the firmware?

Hello from New Zealand

2017-04-18T06:33:14Z

Hi,

I've just finished putting together a Velleman k8200. Was quite a bit more work than I was expecting, but I took it easy and it seems to have come together mostly ok. Seems the controller board is faulty as it doesn't recognise the heated bed, but manually controlling it with an external power supply has let me make a few test prints.

Currently printing out some cogwheels for my home-made robot arm and mulling the possibilities.

Cheers,
grist.