<![CDATA[SoliForum - 3D Printing Community — E3d V6 thermistor table?]]> 2017-06-08T00:56:09Z PunBB https://www.soliforum.com/topic/16335/e3d-v6-thermistor-table/ <![CDATA[Re: E3d V6 thermistor table?]]> I don't know if this helps but I am going through a ramps upgrade on my printer.  I found that the circuit board in the stock print head contains the pull up resistor for the thermistor.  I was getting incorrect temp reading until I used their resistors.  I am not sure what ohms they are.

]]> https://www.soliforum.com/user/17025/ 2017-06-08T00:56:09Z https://www.soliforum.com/post/135924/#p135924 <![CDATA[Re: E3d V6 thermistor table?]]> Check the github FAQ :
https://github.com/luc-github/Repetier- … issues/104

Davinci board is not RAMPS board so usual change won't work -
#define EXT0_TEMPSENSOR_TYPE 8 is not the solution

]]> https://www.soliforum.com/user/8495/ 2017-04-14T09:45:26Z https://www.soliforum.com/post/134547/#p134547 <![CDATA[Re: E3d V6 thermistor table?]]> #define EXT0_TEMPSENSOR_TYPE 8

+ PID autotune

]]> https://www.soliforum.com/user/14138/ 2017-04-13T07:38:55Z https://www.soliforum.com/post/134511/#p134511 <![CDATA[E3d V6 thermistor table?]]> I just installed a genuine E3d V6 in my Advancing 1.0a flashed with Repeater. 92. I can not seem to find a straight on the topic of the thermistor settings. Some places it says I need to change the settings in the firmware,  some say I need do change a resistor on the motherboard, and some say to just leave the settings where they are. Can anyone help me out? I am using the new thermistor that came with the E3d V6.

]]> https://www.soliforum.com/user/8728/ 2017-04-13T07:33:24Z https://www.soliforum.com/post/134510/#p134510