<![CDATA[SoliForum - 3D Printing Community — opengl error]]>2017-04-12T07:24:31ZPunBBhttps://www.soliforum.com/topic/16329/opengl-error/<![CDATA[Re: opengl error]]>Been a long time since I used xyzware but if I remember correctly, it's a graphics card driver issue.
Basically, your card doesn't support the correct version of opengl.
]]>https://www.soliforum.com/user/6872/2017-04-12T07:24:31Zhttps://www.soliforum.com/post/134488/#p134488<![CDATA[Re: opengl error]]>yea, it's stalling out on me, but then again the part may be stalling out the program.]]>https://www.soliforum.com/user/8004/2017-04-12T00:02:04Zhttps://www.soliforum.com/post/134483/#p134483<![CDATA[Re: opengl error]]>Yes, I am have same or similar issue. Not necessarily an error since it still prints. but it is reporting that I have openGL 1.5 and it wants 2.0. I should note that I am a brand new user and have not not seen this error.]]>https://www.soliforum.com/user/16642/2017-04-11T23:50:19Zhttps://www.soliforum.com/post/134482/#p134482<![CDATA[opengl error]]>so i went to use xyzware today, and got an error regarding opengl. has anyone else had this problem? i updated my video cards drivers, downgraded and upgraded the xyzware, and cant seem to get the program to work. if i have to i can just substitute the gcode on the sd-card, but id rather not have to do that. program seemed to work fine until i exported a part, and not a complicated part ether. has anyone found a way to get around this problem?]]>https://www.soliforum.com/user/8004/2017-04-11T23:35:51Zhttps://www.soliforum.com/post/134480/#p134480