SoliForum - 3D Printing Community — Startpoint of print: changeable? DaVinci Mini W

Re: Startpoint of print: changeable? DaVinci Mini W

2017-03-19T04:03:54Z

Carl:
Thanks for your reply. I could not find anything in settings or advanced settings, therefore the question. I don't believe adding this function would be a big deal for XYZ while enhancing the possible print quality just with a couple of lines of code.

Re: Startpoint of print: changeable? DaVinci Mini W

2017-03-19T03:57:03Z

volkhard wrote:

I am trying to print some wheels. The print starts at the same point for every layer leaves a small bump on the object. Is there a way to set this starting point to change for every layer of random?

For most slicers and printers yes, but for such a proprietary system as XYZ makes probably not unless it in the settings or advanced settings of your software.

Startpoint of print: changeable? DaVinci Mini W

2017-03-19T03:22:30Z

I am trying to print some wheels. The print starts at the same point for every layer leaves a small bump on the object. Is there a way to set this starting point to change for every layer of random?