<![CDATA[SoliForum - 3D Printing Community — What's the issue with sticking ???]]> 2013-03-05T18:02:25Z PunBB https://www.soliforum.com/topic/1594/whats-the-issue-with-sticking/ <![CDATA[Re: What's the issue with sticking ???]]> I went to glass/hairspray so that I could keep the bed hot and get setup for another print without using a pry bar.

]]> https://www.soliforum.com/user/134/ 2013-03-05T18:02:25Z https://www.soliforum.com/post/15124/#p15124 <![CDATA[Re: What's the issue with sticking ???]]> De-lamination is just part of the fun smile

Actually I had no issues with sticking on the original bed with the kapton, but I did have de-lamination of the edges, but that's a bed issue.  I switched to glass-hairspray and re-calibrated.  Still have the de-lamination on some of my larger prints, but it's gotten better.

]]> https://www.soliforum.com/user/129/ 2013-03-05T16:41:42Z https://www.soliforum.com/post/15116/#p15116 <![CDATA[Re: What's the issue with sticking ???]]> I haven't had any sticking problems after I got everything calibrated.  Before calibration I had all sorts of issues.  I also switched to glass so I can switch beds easier.  I don't have to wait for the bed to cool down to remove the part only to heat back up again.

]]> https://www.soliforum.com/user/253/ 2013-03-05T14:27:47Z https://www.soliforum.com/post/15100/#p15100 <![CDATA[What's the issue with sticking ???]]> Hi, not posted for some time, but still having a great time designing and printing stuff.

I was just reading the forum and it's impressive all the posts about using hairspray and other stuff to make the ABS stick to the krapton bed..... but what' the issue ? I just leave mine heat to 95° and it sticks fine (big parts, small parts, ...) ? Also, just leave it cool down to unstick (to avoid damaging the krapton)... So what's all the fuss about?

]]> https://www.soliforum.com/user/121/ 2013-03-05T13:38:17Z https://www.soliforum.com/post/15098/#p15098