SoliForum - 3D Printing Community — Da Vainci Jr. Bed adhesion method?

Re: Da Vainci Jr. Bed adhesion method?

2016-12-23T23:54:55Z

carl_m1968 wrote:

totalitarian wrote:
carl_m1968 wrote:

Use Elmers purple glue stick. It works much better on cold beds.
Do you apply it straight to the glass?

yes and just wait fro the purple to go away. If you do have trouble removing the object just soak it and the glass in water.

Great I'll give it a go thanks

Re: Da Vainci Jr. Bed adhesion method?

2016-12-23T23:50:53Z

totalitarian wrote:

carl_m1968 wrote:
totalitarian wrote:
Just tried printing on the tape that came with my Jr. and the print stuck a little too well. I had to remove the glass and use a chisel to get the print off.
Anyone else have better success?

Use Elmers purple glue stick. It works much better on cold beds.
Do you apply it straight to the glass?

yes and just wait fro the purple to go away. If you do have trouble removing the object just soak it and the glass in water.

Re: Da Vainci Jr. Bed adhesion method?

2016-12-23T23:09:37Z

carl_m1968 wrote:

totalitarian wrote:
Just tried printing on the tape that came with my Jr. and the print stuck a little too well. I had to remove the glass and use a chisel to get the print off.
Anyone else have better success?

Use Elmers purple glue stick. It works much better on cold beds.

Do you apply it straight to the glass?

Re: Da Vainci Jr. Bed adhesion method?

2016-12-23T23:04:51Z

totalitarian wrote:

Just tried printing on the tape that came with my Jr. and the print stuck a little too well. I had to remove the glass and use a chisel to get the print off.
Anyone else have better success?

Use Elmers purple glue stick. It works much better on cold beds.

Da Vainci Jr. Bed adhesion method?

2016-12-23T19:20:49Z

Just tried printing on the tape that came with my Jr. and the print stuck a little too well. I had to remove the glass and use a chisel to get the print off.

Anyone else have better success?