<![CDATA[SoliForum - 3D Printing Community — what steps per mm setting for 4 start lead screw, z axis ?]]>2016-12-03T08:29:15ZPunBBhttps://www.soliforum.com/topic/15791/what-steps-per-mm-setting-for-4-start-lead-screw-z-axis/<![CDATA[Re: what steps per mm setting for 4 start lead screw, z axis ?]]>Here I am at up too early you need to factor in for micro stepping so your step count will be higher.]]>https://www.soliforum.com/user/6775/2016-12-03T08:29:15Zhttps://www.soliforum.com/post/128681/#p128681<![CDATA[Re: what steps per mm setting for 4 start lead screw, z axis ?]]>steps per Millimeter: Steps/mm: 200/8.67= 23.068 mm so 23 mm should give a good starting point
this is for a standard 1.8 degree per step motor a .9 degree motor is 400 steps per rev or 400/8.67 or 46 steps per mm
]]>https://www.soliforum.com/user/6775/2016-12-02T23:34:13Zhttps://www.soliforum.com/post/128668/#p128668<![CDATA[Re: what steps per mm setting for 4 start lead screw, z axis ?]]>8.67 mm I looked at RH but I do not now the pitch input?]]>https://www.soliforum.com/user/7268/2016-12-02T21:44:03Zhttps://www.soliforum.com/post/128664/#p128664<![CDATA[Re: what steps per mm setting for 4 start lead screw, z axis ?]]>If you turn the nut one rev how far does it move ? Tin
FYI there is a lead screw calculator under tools in RH
]]>https://www.soliforum.com/user/6775/2016-12-01T00:14:49Zhttps://www.soliforum.com/post/128614/#p128614<![CDATA[Re: what steps per mm setting for 4 start lead screw, z axis ?]]>HI here is a link http://www.ebay.com/itm/361564574771?_t … EBIDX%3AIT]]>https://www.soliforum.com/user/7268/2016-11-30T15:52:37Zhttps://www.soliforum.com/post/128580/#p128580<![CDATA[Re: what steps per mm setting for 4 start lead screw, z axis ?]]>Can you post the link to the item?]]>https://www.soliforum.com/user/9121/2016-11-30T15:46:44Zhttps://www.soliforum.com/post/128578/#p128578<![CDATA[what steps per mm setting for 4 start lead screw, z axis ?]]>HI just upgraded to lead screws for z axis not sure what the pitch is, to set the steps per mm in the firmware? I bought 4step lead screws off of ebay]]>https://www.soliforum.com/user/7268/2016-11-30T15:12:08Zhttps://www.soliforum.com/post/128576/#p128576