<![CDATA[SoliForum - 3D Printing Community — 3d systems cube 3]]> 2016-12-13T00:14:05Z PunBB https://www.soliforum.com/topic/15785/3d-systems-cube-3/ <![CDATA[Re: 3d systems cube 3]]> I bought one for $150 with shipping. Once I use up the two carts it came with I may swap the electronics depending on the quality I get as it is. The carts are still $60 each and hold a 3rd of what you get in bulk. So hacking or converting is a necessary step with these.

I do have a question to those that have one. Mine was shipped with 1000 adhesion slides which are basically microscope slides and the seller claims they are needed and is included as a freebie. Most units don't include but need them according to the seller. However I can find no mention of them in the manual nor have I heard of a need for them in my years of printing. So what are they for or is the seller just shipping extra junk to get rid of it?

EDIT:

Got it running stock right now and these things are noisy.. Sounds like they are over driving the steppers like XYZ did.

]]> https://www.soliforum.com/user/7731/ 2016-12-13T00:14:05Z https://www.soliforum.com/post/129101/#p129101 <![CDATA[Re: 3d systems cube 3]]> Some of you may find this thread on the reprap forum interesting:

http://forums.reprap.org/read.php?1,707941

It's basically about buying these cheap and making them non-proprietary.

]]> https://www.soliforum.com/user/302/ 2016-11-30T20:33:55Z https://www.soliforum.com/post/128608/#p128608 <![CDATA[Re: 3d systems cube 3]]> yup - what Carl said - change out the controller board, load up your favorite flavor of firmware, and go to town with it.

]]> https://www.soliforum.com/user/10399/ 2016-11-30T01:05:25Z https://www.soliforum.com/post/128553/#p128553 <![CDATA[Re: 3d systems cube 3]]> zburhop wrote:

So with all the cheap 3d systems cube 3rd generations around has anyone done anything with them?  I cant find a very good hack for using non 3d systems material.  Im not going to take the plunge knowing that its an orphaned product with proprietary filament without having a way to keep it going on rolls of material.
Zach

You would probably be able to swap out the controller to a Ramps or similar then it would be open source and not limited.  Once you get passed the controller it is just steppers and end stops.

]]> https://www.soliforum.com/user/7731/ 2016-11-29T23:21:21Z https://www.soliforum.com/post/128549/#p128549 <![CDATA[Re: 3d systems cube 3]]> It is an orphan that uses propitiatory filament that is why so cheap. Sorry

]]> https://www.soliforum.com/user/6775/ 2016-11-29T23:06:55Z https://www.soliforum.com/post/128547/#p128547 <![CDATA[3d systems cube 3]]> So with all the cheap 3d systems cube 3rd generations around has anyone done anything with them?  I cant find a very good hack for using non 3d systems material.  Im not going to take the plunge knowing that its an orphaned product with proprietary filament without having a way to keep it going on rolls of material.
Zach

]]> https://www.soliforum.com/user/5254/ 2016-11-29T19:58:52Z https://www.soliforum.com/post/128523/#p128523