SoliForum - 3D Printing Community — Uploaded Successfully

Re: Uploaded Successfully

2016-10-27T23:01:49Z

Sage advice. Thank you!

wardjr wrote:

It's old but so is your printer
That's the best version for your current setup in a pre configured form.
You could pull the latest version of Marlin from Git and set it up for your machine. I have done this and you will notice little to no improvement from your printer. There's only so much firmware can fix.

Re: Uploaded Successfully

2016-10-27T20:43:47Z

It's old but so is your printer
That's the best version for your current setup in a pre configured form.
You could pull the latest version of Marlin from Git and set it up for your machine. I have done this and you will notice little to no improvement from your printer. There's only so much firmware can fix.

Uploaded Successfully

2016-10-27T19:26:34Z

Last night I uploaded Solidoodle-Marlin_v1 firmware for the first time using Arduino 022 IDE. I followed the steps from one of the other threads and was stuck for a bit trying to use 1.0.5 as suggested but going back to the older IDE worked. Is this the favorite firmware? Anything newer out there? I didn't have room for Z hysteresis and wobble so I just loaded wobble as I'm having tons of issues with my prints and have already put spring loaded fix onto Z axis.

https://github.com/ozadr1an/Solidoodle- … in_v1_beta

^-- this is the version I uploaded after updating configuration header and recompiling -- apparently it's like 3 years old so I thought there must be something newer?