<![CDATA[SoliForum - 3D Printing Community — Printing with a 0.2mm airbrush nozzle]]> 2016-09-05T14:44:35Z PunBB https://www.soliforum.com/topic/15474/printing-with-a-02mm-airbrush-nozzle/ <![CDATA[Re: Printing with a 0.2mm airbrush nozzle]]> Now the geckos do not have a big brother...:)

http://up.picr.de/26731156xq.jpg

]]> https://www.soliforum.com/user/15028/ 2016-09-05T14:44:35Z https://www.soliforum.com/post/126772/#p126772 <![CDATA[Printing with a 0.2mm airbrush nozzle]]> Hi,

currently I am a little thing to do when trying out with a 0.2mm airbrush nozzle that.
The here are the prints that I made today.

http://up.picr.de/26715081kr.jpg

http://up.picr.de/26715083sg.jpg

http://up.picr.de/26715085rh.jpg

http://up.picr.de/26715087ta.jpg

The geco is printed with PLA and a layer height of 0.1 mm, the small just 5 minutes and the large after 45 minutes was finished.

But I have so even large characters printed as this dragon with 378mm height.

http://up.picr.de/26414252lf.jpg

The course I also printed in small.

http://up.picr.de/26420297ky.jpg

greetings Edwin

]]> https://www.soliforum.com/user/15028/ 2016-09-04T12:13:53Z https://www.soliforum.com/post/126750/#p126750